P 800.227.4116 F 888.771.7713
DISTRIBUTOR LOGIN
Test Questions
What amperage is the fuse that is used on the P1020-K in the battery box?
5 amp
2 amp
30 amp
The liftgate battery light on the direct nose box is blinking green, what does the indicate?
Batteries are below 12.0 volts
Batteries are above 12.4 volts
Batteries are above 13.2 Volts
Inside the battery box, What position should the 1-OFF-2 selector switch be in for the Purkey’s liftgate charging system?
1
Off
2
If the Direct box has no lights on it, which of the following is not a possible reason?
1-2 selector switch is in the wrong position
30 amp breaker is tripped
Solar is charging the batteries
2 amp fuse on the P1020-K plate is blown
What is the name of the charging system for the Pepsi’s spec?
Direct-01
Direct-21
1.21 Gigi watts
The orange wire on the P1020-K plate routes to the Direct controller, What is the orange wires purpose?
Turn the converter off/on
Supply power to charge the batteries
Power the Direct box
The Status is mounted where?
Nose of the trailer
Side of the battery box
Liftgate platform
The 200 amp circuit breaker is wired between the liftgate batteries and the master disconnect switch
True
False
It is ok to replace the 200 amp circuit breaker with a 150 amp circuit breaker
How often do you grease the platform pivots?
Daily
Weekly
Quarterly
Annually
When checking the oil level to ensure it is at the proper level, the platform should be in what position?
Open and lowered to the ground
Closed and lowered to the bottom stops
Closed and all the way up
Folded and lowered to the ground
What is the BMR-55 raise speed time frame?
12-27 Seconds
13-26 Seconds
8-22 Seconds
9-21 Seconds
The recommended clearance between the columns and the runner pad should be?
Zero, the pad should ride on the runner column
The thickness of two business cards
.012" to .025" using a thickness gauge
either B or C
The tip of the platform does not require adjustment if it is _____ or less of the runners touching the ground.
1"
2.5"
2.0"
3.0"
How much grease should be in the columns of a BMR gate when performing maintenance?
A light film
A ¼ inch layer
None at all
Should be lubed with spray lithium Grease
Maxon uses positive lock connectors on all spade terminals that have a mechanical detent that needs to be pressed to remove the wire?
It is only required to verify the operation of the liftgate with the Master switch on position 1
When order new Maxon liftgate decals you will need to provide the ____________
Year make and model of the truck or trailer
Serial number of truck or trailer
Model of liftgate and year
Serial number of the liftgate
Maxon uses open harnesses to allow for quick and easy repairs